Front heater mixer valve control

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 3, 2013
Threads
3
Messages
8
My 1995 80 has had poor heat output from the front heater since purchasing. The rear heat is hot. The front just doesn't get very warm. After a heater core flush which was no help I found the problem. The Mixer door under the dash in the passenger footwell is not properly opening and closing. I can manually open and close the door which solves the problem but I can't get the servo motor to open and close the valve properly. The servo seems to operate. I can't figure out how the arm is supposed to attach to the servo at what angle. I have included some pictures of the control arm and the valve. In the picture the screw holding the arm is loose. I can't find any diagram of the system in the service manual. And I can't find any photos online. Can anyone with a properly functioning arm and valve please post a picture of how it is supposed to look.

IMG_3336.webp


IMG_3338.webp


IMG_3341.webp
 
Is that a hole drilled through the box in line with that screw? as if someone drilled a hole to loosen/tighten the screw?
 
The hole was my work trying to loosen the screw. The picture answered the question nicely. The bracket on my truck was somehow straightened. I bent it back to 90 degrees and it works perfectly. Thanks Again you guys are awesome!
 
Back
Top Bottom