Front End Noise

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 15, 2007
Threads
54
Messages
252
Location
Arkansas
OK, I have been searching for past 2 hrs and found lots about this. Unfortunately I have found nothing about the problem I am having.

My issue is: when slowing down, (15mph to stop) I get this wah wah wah noise. Sounds like from right front. It vibrates some since adding OME medium lift. The noise has been there since I got the truck, the vibration @ heater core area is new. All this is taking place on a 91 with stock tires and wheels, just the lift. I do have the CC bushings installed.

Please help,

Mark
 
They were greased ~1000 miles ago

I have had the vehicle for 1000-1500 miles. The u-joints were done as part of my baselining the truck. Since the lift, this has gotten worse.

Thanks,

Mark
 
Does it do it when braking and not? Try braking with the e-brake.

Where is the noise, can you hear it from the floor of the pass side?

I have the same problem and could feel and hear it from the floor of the pass side where the cat is.
Problems I found when looking: broken sway bar mount bracket, heat shields in front of cat, loose wheel bearing. None of these solved the noise problem.

I think I solved the problem, the muffler mount is broken and when driving slow the nobby tyres shake the exhaust so that the noise is transfered to the cat mount.
I will be making a mount and will see if the noise goes away.
 
The u-joints were done as part of my baselining the truck. Since the lift, this has gotten worse.

What does "done" mean? Greased or replaced? If only greased then the fact that changing the operating angles by lifting the truck would exaggerate the problem. If the u-joints aren't new and of unknown age I'd replace all 4 and go from there.
 
landtoy, I read your post while searching

It does it when braking and when not. I have 3FE which exausts on drivers side. So I think the issues aren't the same. I haven't tried braking w/ ebrake. I am going to try dropping the front drive shaft and driving around the block.


Mark
 
I think I will heed the advice

I am going to drive it w/o the front shaft, but I suspect taking the shaft out and driving will only save me time replacing the u-joints.
 
Any idea on OEM u-joints price?

Mark
 
Back
Top Bottom