Good day all!
I'm the proud newish owner of a 1994 fzj80 up here in Quebec Canada. The left side axle seal is leaking, so I'm looking at getting a knuckle rebuild kit. (most likely from cruiser outfitters based on all the reading I've done here)
But that's not why I'm posting. The pinion has quite a bit of up and down wiggle, when I grab the front driveshaft and move it around, the pinion moves enough to go clunk a little. Uncoincidentally, I have a bad wobble at about 50km/h. The wobble stabilizes until about 105km/h it comes back again. I need to balance my wheels, and even maybe get new tires. But I believe the wobble is at least partially caused by this diff issue.
I would like anyones advice on how dangerous this can be. The truck is going north for the summer. About 2 months and over 5000km. I was set on rebuilding the knuckles before the trip, and maybe next year opening it all up again to install a diff lock. But now that I know about this loose pinion bearing?, I'm wondering if it's too dangerous to leave as is for that long of a trip.
Let me know what you think, if I have to neglect the 4runner and dump some money into the 80 right away, or what.
Also open to suggestions on what else to do while I'm working on the axle. (This is my first solid front axle) I've seen endless parts and upgrades, what's good what's unnecessary? Chromoly shafts, why and which ones? Manual locking hubs?
Thanks all
I'm the proud newish owner of a 1994 fzj80 up here in Quebec Canada. The left side axle seal is leaking, so I'm looking at getting a knuckle rebuild kit. (most likely from cruiser outfitters based on all the reading I've done here)
But that's not why I'm posting. The pinion has quite a bit of up and down wiggle, when I grab the front driveshaft and move it around, the pinion moves enough to go clunk a little. Uncoincidentally, I have a bad wobble at about 50km/h. The wobble stabilizes until about 105km/h it comes back again. I need to balance my wheels, and even maybe get new tires. But I believe the wobble is at least partially caused by this diff issue.
I would like anyones advice on how dangerous this can be. The truck is going north for the summer. About 2 months and over 5000km. I was set on rebuilding the knuckles before the trip, and maybe next year opening it all up again to install a diff lock. But now that I know about this loose pinion bearing?, I'm wondering if it's too dangerous to leave as is for that long of a trip.
Let me know what you think, if I have to neglect the 4runner and dump some money into the 80 right away, or what.
Also open to suggestions on what else to do while I'm working on the axle. (This is my first solid front axle) I've seen endless parts and upgrades, what's good what's unnecessary? Chromoly shafts, why and which ones? Manual locking hubs?
Thanks all