Front axle service

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 15, 2007
Threads
126
Messages
1,134
Location
Los Angeles
I'm digging into my first birf job this next weekend with parts from CDan and help from Mkfour and others in socal, but I cant seem to find a write up on cleaning out the axle housing and 3rd member.

After draining my front diff fluid last weekend (looked like thick, black, pudding mix) I'm sure I need to clean as much of that junk out as possible while I've got the axles out next weekend. How should I go about this? Did some searches, but couldnt come up with much detail.

Advice?
 
I did a truck with a real bad case of the grease migrating into the axle. I ended up pulling the 3rd and basically mopped everything up. When I pulled out the 3rd it had a very thick coating of grease and I ended up wiping as much off as I could and then gave it a Kerosene bath to wash out all the grease in the bearings and such. I then had the owner change out the gear lube after a few long drives while it was hot to get what was left out. Pretty nasty job.
 
Is there anyway to clean the 3rd out short of removing it?

If not, how much time would it add to a front axle job to take the 3rd out and clean it up and reinstall?
 
I had birf soup in the axle when I did my service a few years ago. I did a couple of drain and fills over the first hundred miles, it cleared it up substantially as a result of that. Don't think a little grease in there is going to hurt anything, but I'd drive, drain and fill it a couple of times.
 
Funny, I was just thinking last night about a homemade tool that could be used to go in from the end of the axle to pull out any grease; like a rubber flapper on the end of a pole; pushes in flat, then pull a cord to pull the flapper upright, then pulling back to scrape it out??

Or,, a giant Q-tip, to push the grease toward the diff, but then you have to get the grease out of there. Or, a solvent pump/hose system and a big pail; then just spray the solvent from the end of the axle toward the diff, with the drain plug out; would need a lot of solvent at high pressure I think.

What I did with mine was to drain the muck from the diff; then add a quart of engine flush with two quarts of gear oil then drove it only 10 miles, then drain (frothy muck came out), then refill with gear oil only; drive 10 miles, then drain again, still frothy, but only a few particles came out, then fill again. This time I drove it about 1000 miles until I drained it; I was more curious than anything else to see what it would look like. It came out pretty clean this time; then I added synthetic gear oil.
 
Back
Top Bottom