I know this thread has been beaten to death! Well I want to flog it a little more [:-o
The installation of my 1992 TBI engine into my 1975 pig is going pretty good really. The engine runs great at idle and at high RPM, until the battery goes dead, then it shuts down. Yea, that's right, another flogging of the reborn alternator thread!
Below is a pic of the setup. It is, was, a new CS130 alternator. The trouble I am having is getting it to charge past 12 volts. I can't get it to energize at all. I have three black/Yellow wires coming out of the drivers side harness of the wagon. Plus that side also runs all the old smog wiring hookups (blue wires) and the guage sensor wires (yellow wires), and of course the infamous Green/white wire. One of the black/yellow wires connects with the green/white wire, both of which origianally connect to the stock alternator. The only time I have had any luck to get it to charge was hooking up the brown wire from the alternator to one of the other black/yellow wires. When the engine started, the volts jumped upto ~14 dropped down ~10 volts repeatly for a about a minute, then just dropped to 8 volts and the engine died. That I think was the end of the voltage regulator in the alternator. Now I can't get it to charge at all not matter what wires are connected or with the diaode. What do you think, did I cook the regulator? But I don't see how that would fry it?
The installation of my 1992 TBI engine into my 1975 pig is going pretty good really. The engine runs great at idle and at high RPM, until the battery goes dead, then it shuts down. Yea, that's right, another flogging of the reborn alternator thread!
Below is a pic of the setup. It is, was, a new CS130 alternator. The trouble I am having is getting it to charge past 12 volts. I can't get it to energize at all. I have three black/Yellow wires coming out of the drivers side harness of the wagon. Plus that side also runs all the old smog wiring hookups (blue wires) and the guage sensor wires (yellow wires), and of course the infamous Green/white wire. One of the black/yellow wires connects with the green/white wire, both of which origianally connect to the stock alternator. The only time I have had any luck to get it to charge was hooking up the brown wire from the alternator to one of the other black/yellow wires. When the engine started, the volts jumped upto ~14 dropped down ~10 volts repeatly for a about a minute, then just dropped to 8 volts and the engine died. That I think was the end of the voltage regulator in the alternator. Now I can't get it to charge at all not matter what wires are connected or with the diaode. What do you think, did I cook the regulator? But I don't see how that would fry it?
Last edited: