FJ80 Cummins Engine Swap - Help!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 2, 2019
Threads
1
Messages
1
Location
Connecticut
Hey all, this is the first time I've registered and posted after looking through the forums. My dad has a 96' diesel FJ80 in Indonesia (he lives there, I live in CT) and is thinking of repowering it with a 5.9 Cummins. When I get the 5.9 I'm exporting the motor there. My question is, does he need to replace his 5 speed manual to handle the torque or replace anything in the drivetrain? What else would he need to do? I do apologize for my ignorance, I've just started to get into the offroading world, it is exciting. My dad uses his landcruiser to tow gensets and also force people out of the lane because a landcruiser is about as big of a car you can get over there haha.

unnamed.webp


c848c03f-37a5-4c9c-9c33-a921c0b3a64f.webp
 
Hello Gudris,
If more power is what your dad wants, all you have to do is turn the little nut behind the pump 1/4 to 1/2 turn clockwise to open the pumps diesel flow. Also, you want to install 3 washers to the turbo to pull the diaphragm faster to give it more pressure.
That is what I did to my 94 with 1hd-t 12 valves.
 
There is a lot of documented information on what it takes to swap a 12v cummins into an 80 available here in the 80 series tech section. My signature below has a link to my build thread that is one of the more comprehensive threads. @Wheelingnoob also has a very detailed build thread.

In short...yes there is a lot more you need to do. No one has adapted a toyota 5 speed behind a cummins yet, most like myself have used an NV4500 and modified the mainshaft, some have gone the toyota auto route with a custom belhousing.
 
Back
Top Bottom