- Vehicle Model
- 60 Series
- Location
- United States
I have my old HJ60 frame that had a shifty patch job with my 110 welder. The only place needing attention was the rear springs front perches. I did run it for a couple years and I consider it solid. Anyone with a good welder can grind the old welds and lay proper bead to make this a lifetime frame. I found a really nice one for my truck when I was doing my resto. I was gonna fix this nice and then perhaps sell it. The engine mounts were cut, because I needed them for my diesel motor but I have 62 mounts that will go with the frame. Prior to going down the rabbit hole, I did do the Trail Tailor chanel repairs on the back section, so that is a plus.
$100.00 takes it.
$100.00 takes it.