FJ40 Wiring Help

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

I rerouted the loom in the front and mounted the regulator. Looks much better, eh?
Small Coil 2.webp
Small Mounted Regulator.webp
 
The rear section is pretty hacked up, of course. Got a little repair to do. :rolleyes:

I found the connector for the fuel sender. Looks like there's a pigtail that I don't have. I think the blue/blue red barrel connectors are for the reverse switch. I also found this pair, black and white/black, I can't explain. They don't start at the plug to the main harness. They just appear out of the loom right at about the same spot as the barrel connectors. I couldn't find anything on the diagram I have in the Haynes manual.

Thanks again for all your help, Todd. I owe you a few cold ones. :grinpimp:
Small Fuel Sender.webp
Small Black and Ground.webp
 
I think you're right about the blue/red and red/blue wires with barrel connectors. Those are for the reverse switch.

Yellow/red and white/black are for your fuel level sender. That white/black ground wire may connect to the chassis somewhere in that area.

Are you sure that's a black wire (with the loose white/black wire)? Are you sure it's not green, darkened by age and dirt? If that pair of wires is green and white/black, it is probably for the seat belt warning switch. It would mate up with the wires from one of the seat belt latches.

There should be at least one white/black ground wire connected to the chassis in that area of the frame.

Get a Toyota wiring diagram. The Haynes manual diagrams suck. I think there might be a '78 diagram in the tech links.


:beer:
 
Pretty sure it's black, but I'll look again. For some reason the PO cut into the white wire in several places, usually right next to the plugs. The red line is cut, too. I've got an un-accompanied green line, which is curious. Then I found a bundle of greens past the middle, crimped with a rubber cap taped on to them. Looks like a factory job to me.
 
Chris,

I'm don't know that there are any black wires in the rear harness. Perhaps it's been added?

The white wires in the rear harness will be for the brake lights (if original). Perhaps a PO cut into these for a trailer connection or for portable brake lights for towing?
 
spotcruiser said:
Yellow/red and white/black are for your fuel level sender. That white/black ground wire may connect to the chassis somewhere in that area.

There should be at least one white/black ground wire connected to the chassis in that area of the frame.

I found a segment of harness in my collection yesterday with the fuel sender connectors on the end. Yeah! I'll have to splice them in to the harness I'm using unless I find a compatible plug. No big deal. It also has a pair of white/black wires crimped to a round connector. I think maybe it is ground for the reverse light switch? Any idea approximately where that one is normally fastened? On the frame rail? Tub? Anyone have any pics? ;p
 
Frame rail, outboard of the xfer. Pretty much the same area where the wires to the tank, reverse, and seat belt wires break out of the main harness.
 
chris, on your connectors, be sure to look inside them well to see if they were actually plugged into something. there are a few connectors that just don't get used.
 
Back
Top Bottom