Finaly lifted

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 12, 2004
Threads
34
Messages
299
Location
The Grove
Got a package in the mail. Js and Ls just under a week delivered. Awesome job to LT at metaltech. Heres the before picture
DSC02443.jpg

Floating cruiser.
DSC02444.jpg

Hydraulics are your friend.
DSC02446.jpg

After shot.
DSC02447.jpg


Now comes the question. What did I do wrong? I don't have any vibes, I feel no difference in steering. I didn't do any caster correction. All feels good
 
Now comes the question. What did I do wrong? I don't have any vibes, I feel no difference in steering. I didn't do any caster correction. All feels good

drive it at freeway speed.
this is what it looks like going in a straight line--> :steer:

unless you like your truck twitchy like it has tourrettes, you will need castor corr.
then the vibes come ;)

good job on the lift, that lift is nice i'm jealous:beer:
 
LOL! Looks much better. I like you lift for install too!

Each truck is different. So not sure on the correction aspects, other than get your caster measured for reference. Then choose to correct and then tackle vibes if any. If your comfy with the handling I wouldn't bother. My was was fine around town, its was a couple road trips I didnt like the twitchiness of iton the freeway. The Slee blue CC solved that easily in my case (OME meds).

LOL x2 what FirstToy said in a clearer statement.
 
lol. In that after shot, the truck has the same amount...

of lift as it did up on that fork lift.:lol:

Me wants!!!:p
 
Hey, the smaller the tire, the bigger looking the lift!

har-har.
 
Got a package in the mail. Js and Ls just under a week delivered. Awesome job to LT at metaltech. Heres the before picture
DSC02443.jpg

Floating cruiser.
DSC02444.jpg

Hydraulics are your friend.
DSC02446.jpg

After shot.
DSC02447.jpg


Now comes the question. What did I do wrong? I don't have any vibes, I feel no difference in steering. I didn't do any caster correction. All feels good


drive it on the freeway at 65 mph and listen for the gggrrrrrrrrrrrr sounds at deceleration, if you don't have that then you may be lucky:D. Nice rig by the way, congrats on the lift.
 
I used a local alignment shop. Cost $15 for the measurements. Some have slided a few beers someones way, and I just found out our local Toyota dealer will measure for free (2nd hand info there, but trusty source).
 
The grrrr sounds like u-joints. How old are they?
 
I thought a dc shaft required the pinion to point at the transfer case. Correcting caster would be moving in the opposite direction. Or am I confused?

in the stock location the pinion points in front of the t-case and then correcting the caster drops it down so it points at it.
 
Back
Top Bottom