fender finishing

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 27, 2006
Threads
124
Messages
1,225
Location
God's Country
I am doing a resto on my '75, looking ahead I am looking for options for paint on oem fenders. Powder coating? Scuff sanding? then painting, etc.
sj:beer:
 
Are you talking about the underside? I have found that sanding the underside and using Zero Rust works well. For the top just prep as you would for any automotive paint job and let her rip.
 
new oem

I should have been more specific. The fenders, and the running boards are new in the box. Just your basic factory finish.
 
Factory primer should be fine, you'll need to red scotchbrite prior to painting, after using prepsol or another grease removal product.
 
I would definately scuff them and clean them like you are painting something that is already painted on the truck.

I bet it won't take too much surface prep from the factory, but prep is where you get all your results.

Rezarf <><
 
powder vs. paint

wonderin' if powder coating is better than painting. I intend on using a 2 component urethane, or powder painting. I have been told to use a scuff pad for new.
 
wonderin' if powder coating is better than painting. I intend on using a 2 component urethane, or powder painting. I have been told to use a scuff pad for new.

The problem with power coating is that you cannot repair it and if you do need to fix it you have to strip it ALL down to metal again. not just the area damaged. a real PITA. I just had to redo a front bumpe this year and the blasting alone was more that a new factory one would cost.
 
Agreed, paint them not powder coat. Powder coat is fantastic for things that do not get exposed to a lot of abuse like under hood and inside the cab. I'm home powder coating all the small crap on mine but will paint every thing else.
 
Back
Top Bottom