- Thread starter
- #21
Well I just got to say thanks to everyone for their inputs,
.
It cost me a bottle of Canadian Whisky for the mech who worked on her, to get her to pass.
When we where going through things, We tweaked the Air Flow sensor screw about 1 1/4 turns to lean. Also found some vacum lines unplugged.
Here are the pass results:
High Speed Test
__________________________
HC --- --CO
Std 220 ----- -------1.20
Reading 91 --------- 0.53
Deviation 1129 -----0.67
idle test
_____________________
HC ------------- CO
STD 220 ------------ 1.20
reading 118 -------- 0.04
deviation 102 -------- 1.16
Thanks again for the inputs.
WoodyFJ80
.It cost me a bottle of Canadian Whisky for the mech who worked on her, to get her to pass.
When we where going through things, We tweaked the Air Flow sensor screw about 1 1/4 turns to lean. Also found some vacum lines unplugged.
Here are the pass results:
High Speed Test
__________________________
HC --- --CO
Std 220 ----- -------1.20
Reading 91 --------- 0.53
Deviation 1129 -----0.67
idle test
_____________________
HC ------------- CO
STD 220 ------------ 1.20
reading 118 -------- 0.04
deviation 102 -------- 1.16
Thanks again for the inputs.
WoodyFJ80
