F me to tears!!!!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 6, 2003
Threads
43
Messages
133
So I was replacing my brake master cylinder and broke off one of the studs on the booster. No biggie, took the cylinder back off and there was about 1/2 an inch of stud left. Vice grips, fire and some PB blaster right? Nah, not for me, snap. Now it's flush with the booster. Options so far:

1. New booster $400 from SOR $350 CCOT, or $250 from cruiserparts.

2. Try to salvage the old booster and maybe use a heli coil or something.

The hole that the master cylinder sits in has some corrosion, and there wer some signs of leakage (i.e. peeling paint), so I'd like to replace it, but not for $400!

Any ideas on where I could get a good one for cheap? I've never dealt with cruisterparts and am kind of leary since their's is only a quarter of the major places...?

Does anyone know what's inside the booster? can I even use a heli coil? or do i have to get the stud out?

Thanks,
Mike
 
I seem to recall that the studs are spot welded to the can. If you feel like taking it apart, it should be a simple matter to weld in another one. You might be able to drill it out and tap a new hole because there are a couple of inches of clearance inside, but there wont be much meat for the threads.

OTOH, you still have 3 studs left.
 
if you take it apart be VERY careful. IIRC the spring inside of it has some good pressure on it and loves to fly out with some force... Not positive, others might know for sure
 
i have been running mine for years with three studs, PO broke it off. i didnt find it till i converted to 4 wheel disc with new M/C.

and i would not worry about buying from cruiserparts.net they are good people and wont screw you over, and if you have any problems with the part they will take care of you. i havent heard of any problems with them. theres is probably cheaper because its used not rebuilt.

is it your M/C thats leaking and causing paint to peel or the vacum canister?
brake fluid will eat the paint off about anything. if thats the case i would just clean it up and use it. and replace the M/C
 
hit up the local junkyard. brake boosters from most any Toyota truck/car are similar in mounting hole dimensions. Seriously, there is NNNNNNNNNNNNNNNNOOOOOOOOOOOOOOOO reason to pay more than $40 for a good booster.... i have had very good luck with later(late 80's-early 90's) boosters from misc Toyota cars and trucks from pick your part or ecology.
 
I bought a front output shaft for my TC to switch from vacuum to twin stick setup from Cruiserparts and the price was great. THe part cam pretty dirty like it just got pulled off a junkyard rig, but with some TLC and elbow grease its good as new. Only info I got fer ya on Cruiserparts.....
 
Hossdog said:
I bought a front output shaft for my TC to switch from vacuum to twin stick setup from Cruiserparts and the price was great. THe part cam pretty dirty like it just got pulled off a junkyard rig, but with some TLC and elbow grease its good as new. Only info I got fer ya on Cruiserparts.....

Yep, cruiserparts is good. Things will arrive very dirty but working, and they ship fast by the least expensive method possible. Definitely worth trying.

It's also worth asking them about stuff not listed in their website. They've got a muddy field full of land cruisers out there and can go out and pull whatever you need if it's there.

Good folks too.
 
Back
Top Bottom