Exhaust manifold > downpipe studs

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 11, 2008
Threads
63
Messages
321
Location
London, UK & Lusaka, Zambia
Sheered a stud when attempting to replace the downpipe.
Before attacking the others, I'm thinking that a gas torch on the manifold (at the flange/studs) where it goes into the downpipe, then just undo the nuts taking the studs out with them - rather than shearing them off !

Is this a good plan ? Better idea much appreciated !
 
Hi mate,

Mine failed the MOT in October for a leaking front pipe - three times it was off and on before the test station were happy with my repair (Toyota wanted £1123.30 for the front section so be careful).

You won't have much room to get the torch in there safely but give it a go.

My studs came out with the nuts - I had soaked them in WD40 the night before - just be patient - and maybe try tightening them up a little -that works sometimes.

Easiest way to get at them? Long extension on your ratchet, with a knuckle and the 14mm socket, lay under the truck and thread it up from underneath. Its very difficult to get at from the side.
 
I had to remove mine to replace it, I managed to find a new aftermarket down pipe for £180 and that included the 1st cat, Like "Lovely Boyo" said, a Toyota down pipe is well over £1100

A week before I tempted to remove the nuts I made a long extension tube to my release fluid spray can, so I could direct the fluid exactly where I wanted it to go, and that can be done through the wheel arch with the wheel on and sprayed them twice a day.

Before I tried undoing the nuts, which is done from under the car with a combination of extension bars to get the right length, I would put the socket on the nut with the extension bars and hit the end of the extension bar has hard as you can with the biggest hammer you can use under the car, hit it atleast 6 times, when you try and then undo the nut and it it still feels like it is going to shear before it undoes, do the hammer trick again.

When you try and undo the nuts, you will need to have a length of pipe on the ratchet which will need to be 2 ft long so you can get a lot of leverage, all of my nuts finally came undone useing the method above.

I wish you luck, but you will have to use a release oil/spray for atleast a week before hand.
 
Excellent, thanks both :)

Managed to get the pipe and front cat for £120 on fleebay, looks OK . I didn't even ask Toyota, I can just imagine the prices over here !

Will look at it this weekend...

ATB - JB
 
PB Powerblaster works better than WD40 - so does liquid wrench.

I put two long extensions w/ the 14mm deep drive (6 point) and hit it with the impact wrench. All of them came out studs and nuts together.
 
Mind you, A toyota down pipe will probably fit without any hassle, the one I got needed quite a bit of heating up with oxy acyt heat and had to bend the tubes so they would mate up properly, so don't expect it will just bolt on ok
 
Mind you, A toyota down pipe will probably fit without any hassle, the one I got needed quite a bit of heating up with oxy acyt heat and had to bend the tubes so they would mate up properly, so don't expect it will just bolt on ok

Yeah, I'm not expecting perfection for the money I paid ;-)
 
Back
Top Bottom