Engine/Tranny Swap questions

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 15, 2007
Threads
46
Messages
287
Location
Aberdeen, NC
My current set up is a '72 FJ40 with a 77 2F mated with the '72 3 speed transmission and transfer. Would a '79 2F and transmission bolt up directly to my '72 transfer? What are the length differences between the 3 and 4 speed transmissions?
 
My current set up is a '72 FJ40 with a 77 2F mated with the '72 3 speed transmission and transfer. Would a '79 2F and transmission bolt up directly to my '72 transfer?


Yes it will ‘bolt up’, however, you will need to find the special 16 spline input gear that will permit you to use the three-speed transfer case behind the four-speed transmission, along with the different transmission output shaft support bearing that is installed behind the cone PTO cover on the rear of the transfer case, and the other spacer(s) and nut/washers for the output shaft.




What are the length differences between the 3 and 4 speed transmissions?

4+ inches, iirc.
 
The three speed is shorter, AFAIK. The case will bolt up, but you need one gear you can get from Mark's Offroad. Then you'll need to deal with drive shaft length. The '79 shafts won't bolt up to your stock pinion flanges. If you could find a set of axles from a '78 you could get disc brakes and fine spline pinions, then use stock drive shafts out of the '78 or the '79. The '79 axles have 3.73 gears, which would kind of defeat the purpose of using the older t-case.
 
Back
Top Bottom