Engine swap vs TPI/TBI conversion

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 6, 2013
Threads
13
Messages
106
Location
NW Florida
Hey all, looking for opinions. I have a 78 40 that I bought in 2013 with an SBC conversion already done (engine looks to be from a 70-75 Camaro/Chevelle/something) mated to the stock 4-speed. I am looking to improve fuel economy and driveability. The options I am considering are:

1 - convert the current SBC to TPI
2 - replace the current engine with an LM7/L33 or something similar and keep the rest of the driveline
3 - replace the engine and trans with the same engines, mated with a 4L60 or 4L65

Looking for thoughts on cost, labor, and "ease" such as it is. Initially, I thought the TPI conversion was cheapest by far, but I think once I am in the new manifold, fuel rails, harness, etc I am approaching the cost of a LM7 with 80-90k on it. Also, I am decent with a wrench, own a MIG welder, ect, but I'm not a fabricator.

What I dont want to do is take the truck off the road for years as I slowly figure it out, nor do I want to pay the quoted ~$10-$15k for my localish LC shop to do the engine swap.

Thanks,
Eric
 
Lots of good advice

Thanks! I am in Virginia, but using my Mil benefits the truck remains registered in Florida, so legal things aren't the primary limiter. Copy all on the EFI, and I'd started to figure that out on my own, but am often slow on the uptake...

I guess the real question would be sourcing the engine and transmission...my wife doesn't drive stick so I'm not wholly adverse to an auto, but then I need to worry about custom drive shafts and the like. The truck has a 4" life and is on 33s as well, so I wonder if angles won't become an issue as well...

Lots more research to do.
 
not sure, but if going with an auto trans, length could be an issue.
 
Back
Top Bottom