EGR Fault??

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 3, 2015
Threads
72
Messages
384
Location
Lonely Nevada
Website
www.willenosphotography.com
I just finished up a complete massive baseline of our recently purchased LX w/100k on the odo. Completely overhauled the entire EGR circuit as part of the baseline. Replaced the EGR.. Modulator.. VSV and all associated hoses. Checked all of the ports in the throttle body for blockage. I still have a P0401. Sheesh.. where to next is the question? Only thing that I can imagine that might be a problem.. is the "P" and "R" hoses being reversed. Since they both come from the same part of the throttle body.. I "can't" figure out why that would make a difference. But I am open to being wrong. So could it be a problem?? Also anything that I might have missed? Only owned an 80 since March last year.. but learning REALLY fast.. but certainly still missing a lot of tech savvy so I am all ears!
 
I looked at the EGR in the FSM (factory service manual) a couple day ago and it would make a difference if you had R and P hooked up wrong.
Is the emissions sticker still on the underside of the hood? Hook up hoses per the schematics.

Have you done the tests per FSM? Did you clean the carbon out of the intake plenum? Did you blow out all the steel vacuum lines and ports on throttle body and intake plenum?
Read up on egr functions, hook up a "T" in the vacuum hoses to and from the EGR and run a hose to the cab and use a vacuum gauge to monitor if vacuum likes are getting vacuum when they should be getting vacuum.

Are you sure all vacuum hoses are hooked up properly under plenum?
Test charcoal canister and other emissions that run off vacuum to see if they work, maybe you hooked something backwards.

Start there and get back to me if you still have problems.
 
May be simple, did you reset the code after you did the work? This can be done by disconnecting the battery.
 
May be simple, did you reset the code after you did the work? This can be done by disconnecting the battery.
Less invasive to pull the 15 amp EFI fuse in the fuse box on the left fender. Same result, less work.
 
Thanks for all the great responses. I have enough new info that I am sure will result in a cure. After I nail it down.. I will be sure to post the results some time in the next week.
 
Back
Top Bottom