Early Wheel Well Supports?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 5, 2004
Threads
143
Messages
6,764
Location
Paint Lick, KY
Website
www.globalsoftware-inc.com
I was browsing around CCOT's site and happened to see they offer rear wheel well supports for the early Fj40's. They mention that the early versions are taller and have the 'proper notch'. Well since the early versions never had them in the first place exactly what is this notch for? Nothing on the wheel wells of my 1971 would require it.

I've tried to call to ask but their lines are busy. I'm going to be putting in a roll bar and these look like they would help support it. I will eventually tie it into the frame when I add the front hoop and bars. Think they are worth the $97.00?
 
Hi All:

I have a '68 tub on my '74 FJ40. No wheel well supports on a '68 tub. No worries!

When I mounted the full roll cage I fabbed some backing plates from 1/4 inch mild steel plate. Helps spread-out the stress of the cage. Use an "UniBit" when drilling plate steel; it cuts it like butter! (said in a Brooklyn accent!)

Regards,

Alan
 
Sorry for the late reply but I travel to much...

Poser I have a roll bar from, Man-a-not Fre (I think) and was wanting to get the metal tech kit to add the front hoop and supports for it. After looking at several setups I decided to get the supports. They will provide a great tie in point.
 
Coolerman said:
I was browsing around CCOT's site and happened to see they offer rear wheel well supports for the early Fj40's. They mention that the early versions are taller and have the 'proper notch'. Well since the early versions never had them in the first place exactly what is this notch for? Nothing on the wheel wells of my 1971 would require it.

I've tried to call to ask but their lines are busy. I'm going to be putting in a roll bar and these look like they would help support it. I will eventually tie it into the frame when I add the front hoop and bars. Think they are worth the $97.00?


Au contrare!:)
https://forum.ih8mud.com/showthread.php?t=88029

Seems like they did have them up until about '66-'67


Ed
 
I too am going to be cutting my old ones out and I can't see what's the appeal of the design. Why not use some 3/16 or 1/4" thick flat bar and weld it "into" the well?

The factory design seems like a moisture trap to me!
 
Back
Top Bottom