Driveshaft Angle

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Shims, or if it is too far off remove the spring perches and reweld them. If the ujoint angles are the same and you don't have any vibes it is fine at whatever angle it is. If the angle is very severe it will lessen your ujoint's lifespan.
 
Last edited:
mdjohnsen said:
My rear is way angled.






This is beyond ambiguous.




Do you have any numbers?


How do you know that you need to straiten it out?


Without any real numbers on things, there is no accurate way to help with this.


Get a magnetic base angle finder and put it on your drive shaft and tell us what the angle is to start with. Then I would measure what the transfer case is sitting at, and also the rear axle. Perhaps then, we can offer up some helpful suggestions on this.


Anything else is simply wasting time.




Good luck!


-Steve
 
I bet you are okay. Do you have a CV joint at the tcase? (looks like a softbal shaped thing at the tcase end. and is your pinion pointing right at the tcase?
 
On my FJ I've had a very big problem with rear shaft; I took a shaft with double joint from a HJ 61 but I broke it after 500 mt of road driving.

I have 34° of maximum angle plus about 12° of lateral angle; and the minimum distance between t-case and axle is about 18,5".

I built a double double joint shaft:

aaa.sized.jpg


and I turned the axle to reduce the angle and to spread it on each joint.

Now it works great; of course I only drive offroad and I'm sure that driving on road, at 50, 60 km/h for long time would damage it...

But I'm going to low a little bit the car, so the shaft can work better.

Francesco
 
If you have a Double cardan sections on both ends of the DS you do not need to turn the pinion up at the tcase.

One DC is when you turn the pinion up at the tcase.
 
Ok. I have pics of the angulation. I don't have numbers because the angle is so obviously I bet someone like Poser could eye it and tell me to the millimeter. So, here they are.

driveshaft_rear_front.webp

driveshaft_rear_full.webp

driveshaft_rear_full_close.webp
driveshaft_rear_front.webp
driveshaft_rear_full.webp
driveshaft_rear_full_close.webp
 
do you have vibrations??


Your Tcase end should be a Double cardan joint. Not the standard U joint.
 
check the phone book, you should have a drive line shop around some where. they should be able to make you one. measure the distance from flange to flange and take it to them and tell them you need a DC on one end and they will make and balance it. but it wont be cheap, i had a drivline leangthened and balanced with 2 new u-joints and it cost me $177.00 but that was at the best shop in the area. i could of got it done cheaper but i always believe you get what you pay for and this place has the best reputation around.
 
mdjohnsen said:
No crazy vibrations.



If there is not a problem, then what are you trying to fix exactly?


If I were you, I would seriously look at ditching that 205 and adapter, and find yourself a Dana 300 tcase and put it on the back of that SM465 transmission....

Just for starters you would gain:

Rear drive shaft length
Better low range
Far more ground clearance


The availabilty of A LOT of goodies to upgrade that case in the event you wanted to get into beating on rocks with the truck...
 
Back
Top Bottom