Driver Side Door Weatherstripping

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 31, 2003
Threads
952
Messages
10,248
Location
"the whale's vagina", CA
Hi All,

There is definetly a window "leak" on my drivers side door when driving it on the freeway as I can hear it near the glass of the driver side door and not on the other 3 doors. I am thinking that the drivers side door weatherstripping has been compressed and opened too many times compared to the others and this is why I am getting more noise here.

I am thinking of replacing the weatherstripping and was wondering if anyone else has had issues like this, and if replacing the WS solved the noise problems? my truck is a 96

Noah
 
Just did this. I would give it a .005 :banana:
Ordered the drivers door weatherstrip from CDan. Took about 15 minutes. Simply tug the weathertstrip off the top of the door and work all the little platstic "push pins" out around the rest of the door. I found that most o fthose pins stayed in the door. Use pliers to pull those out. You will need to push the pin out that holds the door stop in order to remove the old weatherstrip and fit the new.

The weatherstrip fits in grooves around the top of the window. Reasemble by pinching it into those grooves. On the the front and rear of the door, about where the glass ends, there is a foam tape on the weatherstrip. This has an adhesive that is covered by a little strip. Peel the strip off like a band aid, clean the area and push into place. The little "push pins" simply pop back into the holes where the old one were.

It seemed to help wind noise a little. I might go after the weatherstrip on the body next.
 
Back
Top Bottom