Driveline Binding after Rockbox install

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 18, 2004
Threads
24
Messages
162
I recently installed a newly rebuilt 2F engine and 4 spd transmission out of an '82 FJ60 into my '74 FJ40. Along with the engine and tranny, I installed an AA rockbox and my original 3 spd transfer case. Everything bolted up well, no BFH required.

I took it out for the maiden voyage around the neighborhood last evening but after a few minutes, it felt as though a brake was being applied. I drove it on home and then felt all the brake drums and disks including parking brake, and nothing felt the least bit hot.

After 30 minutes or so, I took it out for another spin and the same thing happened. After it warmed back up, something began to bind.

Has anyone experienced this?

Anybody with any thoughts or questions?

Thanks,

James H
 
I remembered reading from the LCML that a lister forgot to fill up the fluid in his diff...May want to check yours tranny/transfers
 
Everything is full of fluids.


Good question!

James
 
have you jacked up one wheel and spin to see where it binds up?
 
have you jacked up one wheel and spin to see where it binds up?


No, I have not done that. I've now had several hours to think about it and have determined that there are a couple of tests to do to isolate the problem.

1. Your suggestion, jack up rear axle and spin tires.

2. Drive it again and when it begins to bind, put Xfer case in neutral. If it binds, it's from the lower portion of the transfer case back. If it doesn't bind, it's the upper portion of transfer case forward.

Thanks,

James
 
Back
Top Bottom