drive shaft

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

You can use the front drive shaft from an early FJ60 or from an early mini truck, you also may need to cut and turn the axle(do a check of the tech section for spring over conversions). Larry
 
Is it a shackle lift or a spring lift or a combination? I have a 1 1/2" shackle lift in the rear along with 2" lift springs and had very little spline engagement and the shackles rotated the pinion up too far for a 2 u joint driveshaft. I lengthened the rear with a retube and pointed the pinion down with 5* shims and the vibration went away. You can use a CV joint if you point the pinion directly at the TC output. But that will no doubt require shims, too.

When you say axle over, are you SUA or SOA?

Check here....


http://www.4xshaft.com/driveline101.html



GL

Ed:)
 
Hi All:

Did you just get this rig? Has it always had this vibration?

Please clarify the suspension system it has; are the leaf springs above or below the axle tubes?

Regards,

Alan

-------------------------------------------------------------------------
I have 1972 fj40 with a axle over and 3'1/2 lift . I have some rear drive shaft vibration so I belive i need a cv shaft . what should i use?
 
Sorry it's an soa spring over axle
I have had the truck for a while and it had a cv shaft in it . I toasted the cv and I don't know what it came from. I took the cv to some driveshaft shops and they said they could not rebuild it or tell me what it was from. I have a 1987 toyota mini truck front drive shaft with the large bolts but the flanges don't match . The pinion angle is the same as what is recomened for this suspention change. I put in a two joint shaft and have vibrations. 1 1/2" shackles 2" springs
 
Back
Top Bottom