Downey or Advavce?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 25, 2006
Threads
19
Messages
126
It's time to order my engine swap parts and am looking for opinions. I am going to go with a Vortec with a 4L60E auto. Who has the best kits to do this? I have talked to both Downey and Advance and it seems they are about the same. Any suggestions?
 
I will preface my comments by admitting that I have a bias towards Downey because I consider the owner Jim Sickles a personal friend.

That said, I prefer the Downey adapters as a general rule over the Advanced because they are generally more compact than Advanced, leaving more room for longer rear driveshafts, which is something I value.

That said, the compactness of Downey's adapters sometimes causes clearance issues of their own [e.g. tranny pan] that a longer adapter wouldn't, requiring more adapter parts to make the conversion work [read: more $$]

Downey's usually really good at telling you if you're gonna need more stuff than just the adapter kit to finish the job IF you make a point of ASKING THEM!

Hth

Mark A.
 
Thanks for the replies. I spoke with Jim at Downey and he was real helpful. He did say that Downey and AA shared a great deal of engineering.
 
John Smith said:
I would go with Advance for the simple fact that engine swaps and the adapters to make them happen are their core business.

The adapters are not the same, AA's is much longer than Downey's. AA and Downey also sell some of the same stuff, but in this case, it's not. Also, Downey has been making V8 swap stuff for Land Cruisers for a VERY long time. I remember reading the Downey catalog's V8 swap guide 23 years ago before I even bought a Cruiser. And, having built a V8/Auto FJ40 myself, I would never use the AA adapter again. Jim at Downey makes the best adapter in this case - no questions asked. Been there and done that.

Downey is also a TOYOTA specialist where AA is more into Heep stuff than anything else even though they have brought out a lot of Cruiser stuff over the last few years. I would buy an Atlas case any day, and AA does make some great stuff, but here with an Auto trans go Downey. If you do buy stuff from AA, ask for Vic. He is the man.

Downey also makes a lot of cool FJ40 stuff like a nice front driveshaft flange to clear the oil pan, a kick ass fuel cell and some nice motor mounts - all stuff I have bought from them or from Mark's Offroad. All top notch stuff.

-Stumbaugh
 
my64fj40 said:
I have had a AA in my truck for god knows how long and never had a problem....


What it comes down to is a personal preference cause I doubt you will find a huge difference performance wise

I agree with you 100 percent about personal preference, but as far as performance goes, a longer rear drive shaft is going to be better - no way to dispute that.

I never had a problem with my AA adapter quality wise they make good stuff, but the fact of the matter is that if you had run the Downey adapter, it's a lot shorter so you'd have a longer rear drive shaft by about 4 or 5 inches no matter where you motor is. If your talking performance, that's going to make for a longer life on the shaft as the angle will not be as severe. Even with a CV shaft, a longer is better and even more of a factor with a large lift.

I've run both AA and Downey TH350 adapters and I like the Downey a lot more , I think if you have had first hand experience with both units, you'd probably feel the same way.

Having said that, I don't think I'd buy either again, just get what AA does make very well, an Atlas transfercase and run a centered rear axle.

-Stumbaugh
 
Back
Top Bottom