Downey header. . .

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

I had a MAF 6-1 but because of my new steering setup needed it to sweep back faster like the Downey, I didnt change anything else just the ceramic coated header and it does seem to have better thottle response. I must say that I am much happier with the ceramic coating, it seems to make a big difference for heat soak to the cab of my 55
 
I heard gains are minimal at best. Most mechanics that I know say that headers don't do much on Toyota motors. I'd STILL like to see NUMBERS from Dyno testing...Downey gives your numbers for their 2F header but no numbers on their 1FZ-FE. They claim 7HP for the 2F. IMHO, the 1FZ-FE motor has a rather large air cleaner and with a free-flowing exhaust (I run Magnaflow SS CAT and Flowmaster muffler), I don't see where you could improve it much more...besides, it'd have to be an awesome header to last and be worth the trouble to me...not to mention leak...

$.02
 
I heard gains are minimal at best. Most mechanics that I know say that headers don't do much on Toyota motors. I'd STILL like to see NUMBERS from Dyno testing...Downey gives your numbers for their 2F header but no numbers on their 1FZ-FE. They claim 7HP for the 2F. IMHO, the 1FZ-FE motor has a rather large air cleaner and with a free-flowing exhaust (I run Magnaflow SS CAT and Flowmaster muffler), I don't see where you could improve it much more...besides, it'd have to be an awesome header to last and be worth the trouble to me...not to mention leak...

$.02


I would say since they are not bottom end producers anyway the header would mask the seat of the pants at RPM, bottom line are they more efficient than the cast?


How bout extrude honing the OEM cast and having WAYYYYY better long term quality?


Are you 3fe of 1fz?
 
Back
Top Bottom