distributor woe's.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 26, 2006
Threads
6
Messages
18
I have a 74 fj40 with a mallory series 57 distributor that the po installed. I lost spark and traced it back to this magnetic breakerless ignition module. Got the module replaced and I now have spark the only problem is I had to remove the distributor to get part numbers and I now can't get her to start. everything in the haynes and what I've found on here describes the procedures for the point style distr. I'm definately not the sharpest crayon in the box but, what I understand is I get the bb lined up on the flywheel which puts me at 7 deg. btdc. then I line the rotor up with #4 cylinder, seat the distributor, put the cap on, and make that post #1. Then put the rest of the wires in proper firing order and thats it, right?:rolleyes: If someone could elaborate on this I would very much appreciate it, hunting season is here and I am desperatly trying to get her running again.
Thanks
 
If it is 180 degrees out, the simple fix is to move the spark plug wires over 180 on the cap.

If you have removed and replaced the distributor, make absolutely sure that the nose of the distributor is fully seated into the oil pump drive slot before you start it or you will have no oil pressure.
 
You missed one step - the BB can be at the needle twice for each distributor rotation so you need to make sure that the BB you see coincides with #1 cylinder being on it's compression or firing stroke. The simple way to tell is to check the valve rockers. You want them loose (able to feel movement when wiggled by hand) for #1.

If #1 rockers aren't loose then #6 rockers will be and you have it 180 degrees out, one full engine rotation wrong. You can make the #6 plug your #1 in the firing order as Pin_Head described, or not.

I like to reach through the oil filler to feel the #1 rockers and turn the engine by hand (sparkplugs OUT) until I see BB, feel slack rockers, and rotor at #1, but it's your choice to do it whichever way makes the most sense to you.
 
so once I get #1 cylinder where I need it which cylinder should my rotor point to once the distributor is fully seated, #4? If so do I move my wires on the distributor to make this post #1 with the cap on?
 
so once I get #1 cylinder where I need it which cylinder should my rotor point to once the distributor is fully seated, #4? If so do I move my wires on the distributor to make this post #1 with the cap on?

Once it's fully seated it ought to point to #1, of course, if you have the other stars aligned you should not need to relocate any wires.

The reference to #4 is an approximate guide for where the rotor should point BEFORE the distributor gear is engaged with the cam gear. From there the rotor will turn toward #1 as the distributor is lowered into the hole.

Basic four cycle stuff.
 
victory! she started. still got to work on the timing but she's running. Just wanted to say thank you to all you guys, you really saved me alot of time and money.
:cheers:
 
Back
Top Bottom