Disc Brake Woes

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 11, 2003
Threads
23
Messages
402
Location
Fort Worth
Added front discs last week and all was working well until today. Was driving when I noticed a slight squeel when braking, then felt brakes contacting when not pushing pedal. Adjusted the bleeder screws and both calipers released. Started it back up and pumped the brakes and they started sticking again. Any ideas? :confused:


'93 4runner calipers, LC vented rotors, '81 knuckles, '91 4runner master, '73 booster, new NAPA brake lines.
 
Last edited:
I've got one but I didn't put it on cause I've read that some systems don't need one. My fronts were locking up before the rears without it, before this problem started. Even so, would not having a proportioning valve on the rear line cause my front to hold pressure?

Edit--I was thinking proportioning valve, not residual. I have a '91 master.
 
Last edited:
If the calipers release when you crack the bleeder screws you have residual pressure in the line, most likely because you still have the master cyl for the drum brakes (do you) if so you need to remove the residual valve, or replce with a master made for front disc's. If you need one I think I have a good one in my shop somewhere from a 76 fj40, let me know
 
fj40mayo said:
I've got one but I didn't put it on cause I've read that some systems don't need one. My fronts were locking up before the rears without it, before this problem started. Even so, would not having a proportioning valve on the rear line cause my front to hold pressure?

In this post Mayo it sounds like your decribing a 'Proportioning valve' this if diffrent from a residual valve. You usually do not need a proportioning vavle with front disc rear drum.
 
Mayo , you are right about the M/C but it would not hurt just to check and see if there is one in there and my guess is the old booster/ newer M/C combo. sounds like booster is sticking or maybe the booster was preloading the rod when you bolted the two together , I suggest rethinking the rod between booster and M/C
 
I don't know about having to switch masters, I did the MiniKnuckle/vented60Rotor/V64RunnerCaliper Toyota Frankenbrakes and kept my old master. Just took out the residual valve.




fj40mayo said:
Pighead --- My mistake, I was talking about a prop. valve.
I'm using a master from a '91 4runner. I thought the residual valve issue was one of the reasons to use that master?
 
Chris,

If you've checked and there is no residual valve (and you're right, a 91 should not have one), then Peesalot may be onto the solution. It sounds like your booster actuating rod may need adjusting because it's not fully releasing.

To test ... pull the booster vacuum line and plug it. Then go for a ride. Even though the brakes will be very hard you should be able to tell if they are dragging on you.

Rice
 
I'll try that. When I installed the master to the existing booster, I didn't mess with the length of the pushrod. Is the pushrod adjusted at the pedal or on the rod itself?

BTW Rice -- the aussie kicked ass this weekend! Thanks :D
 
If you craked the calipers and it releases pressure then the booster in not the prob. If however you pulled the vacum line and it released pressure then I would say the booster pushrod is likely the culprit.
 
I shortened the rod between the booster and master by about 1/4" and took it for a test ride. I've got a little more pedal than I like, but the calipers aren't hanging up anymore. I'll adjust the pedal height inside the cab and all should be golden. Thanks for all the help. :beer:
 
Back
Top Bottom