Disc brake conversion question.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 13, 2007
Threads
63
Messages
329
Location
Santa Fe, NM
Doing a conversion on a 69 FJ40. I have later FJ40 knuckles and components. I thought I had read up on everything and had all my parts in order. I however failed to read up on the birfield ends I guess. So now after getting the first side put together up to the hub I've realized I have course spline birfield and the Aisin hubs I picked up are fine. So are there course spline Aisin hub or the part inside to swap? I did search and keep coming up with not the right answer. Or am I now looking at a having to get some fine spline birfields?
 
You need to be looking for some fine spline birfs. What was the donor vehicle for the knuckles and hubs? FJ40? What year? FJ60? Mini-truck?
 
Can you post a pick of the spindles and locking hubs?
 
Actually, wheel hubs too. Sounds like this is mix and match set. Pictures will be the best way to sort this out.
 
Here you go.
IMG_20181027_231938.webp
IMG_20181027_232001.webp
IMG_20181027_232053.webp
 
Yes it looks like you are going to need fine spline birfields unless those hubs are course spline. I couldn't tell from the pic.
 
If you'll need to have disc brake spindles and the matching fine splined birfields to go with them.
 
Those are fine spline locking hubs. Those appear to be early coarse spline spindles and birfs, since coarse spline birfs rattle around in a fine spline spindle. You should be looking for spindles and birfs from an FJ60. Does that 'clean' hub fit that spindle correctly with the bearings installed????

If it makes you feel better, years ago I bought a disk brake front axle where the PO had installed coarse spline birfs with coarse spline Warn hubs.
 
I have a pair of coarse spline FWH's, so they do exist. There is however, a disparity in axle length between drum, early disc and later disc. AFAIK the entire assy. needs to match.
 
These are the spindles that I was sold with knuckle and hub housing. The new bearings fit on it fine. I'm pretty sure the knuckles are from a late-model fj40 as the studs are smaller than the fj60 studs that I initially had purchased when I thought these were from a 60.
IMG_20181028_122151.webp

The spindle on the left is the new one at the one on the right is what I pulled out.
IMG_20181028_122010.webp
IMG_20181028_122557.webp
IMG_20181028_122607.webp
 
Back
Top Bottom