dimples?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 27, 2005
Threads
150
Messages
1,705
Location
Sequim, WA
Why do I see some 40's with dimples on the side and some with out? What causes the dimpling? Is it bad/good? The sides of my 40's hardtop has them, I'm trying to figure out if this is normal or not.
Sorry if this has already been posted, I searched.

Thanks for the info

Mike

'78 40/ 350 SBC
 
Did you search using the word "dimples"? If so, did Woody's picture come up?

Woody has the cutest dimples!
 
The bad news is, most FJ40s have weld dimples (if that's what you're referring to). :frown:

The good news is, nobody has bondo'd them up yet. :)


Welcome, PortAngelesFJ40. :flipoff2:
 
The dimples are spotwelds, and they are easily seen in various places around a 40. They're normal if they aren't bulging outward but if they bulge it's a sign of rust between the outer skin and the inner 'framework' . Rust will grow and begin to push the steel out around the weld. It'll eventually break out through the skin. Sometimes you'll see a cruiser with rust in horizontal lines along the top or along the rear sides of the tub. It starts at the dimples usually.
 
later model 40's(think 79? was the change in sheetmetal to 18guage?, but it might have been earler) will show the spot welds even when new. earlier models should not show(as least as much) if so then the spot welds are popping(because of what honk says)

alot of "restored" later model 40's will not show the spot welds, they get filled over

and welcome :flipoff2:
 
Hey Landpimp, I think I have the 18 guage metal? There seems to be a lot of spot welds, and no visible rust. So I think i'm in good shape. Thanks for the info.

Mike

'78 40/ 350 SBC
 
yeah, on my 82's I can see all the spot welds.....as should be. On my 66 fj45LPB....I can see em on the sides of the beds......because they are poping from rust........when new they should not have shown(at least very much)

PortAngelesFJ40 said:
Hey Landpimp, I think I have the 18 guage metal? There seems to be a lot of spot welds, and no visible rust. So I think i'm in good shape. Thanks for the info.

Mike

'78 40/ 350 SBC
 
I think the amount the spot welds show also have alot to do with how much the body is flexed. A truck that has seen alot of off camber offroading, with wheel lifting etc., always shows more than one that's been a parking lot queen. Sometimes this gets pretty extreme...I have purposely not "repaired" dimples when doing resto on a very clean truck in order to insure the next buyer that the tub isn't full of bondo.
 
My 40 has the dimples, at first I thought they were defects. But I have been wondering if mayby the are getting a little deeper, I am showing some rust in other areas, such as front fender supports and a couple of spots in the wheel wells. I am thinking that maybe it is building up between the metal betwwen the quarter and the well. Time will tell if I am correct.
 
Thanks again! Good info.

Mike

'78 40/ 350 SBC
 
Back
Top Bottom