Differential Gear Ratios

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 26, 2012
Threads
56
Messages
175
Location
Baguio City
Hello, I have a 1971 FJ40 which has the following conversions... 1981 2B engine, 81' 4speed transmission and 81' transfer case.

To get the handbrake system to work again, I have to change my differentials so opted to go for the 1980 or similar front and rear differentials. Shop where I get my parts is asking if I want the 4.1 ratio or 3.9.

Not sure which one to go for??? :confused: I know 3.9 goes faster for highway use, 4.1 more for offroad.

Just wanted to know if it makes that big a difference? Should I consider other factors when choosing which gear ratio? My lift by the way is going to be OME 2.5" lift with 33" tires. Mostly on-road use but the occasional offroad most definitely. I don't intend to drive fast on the FJ as it's too dangerous to do so in the first place but may have to make long drives on highway i.e. 5 hour trips once every 3months. Mostly city driving too.

Thanks guys for your thoughts on this.

AL
 
There is not much difference in a 3.90 and a 4.10 gear set but if you're going to be on the road that much, especially long trips, I'd go with the 3.90 ratio if it's an option. Primarily for a little more top end and fuel mileage.
 
On US imported Land Cruisers had 3:70s starting in 1979. Unless your going really big tires might want to you this route. Diesels are a lower RPM engines and you do any highway driving. A H55F with overdrive would another option.
 
I wonder why you need to change diffs to get a hand brake to work?

as living in the past stated it should be 3:70 ratio, hopefully the shop miss quoted.
 
3_puppies said:
I wonder why you need to change diffs to get a hand brake to work?

as living in the past stated it should be 3:70 ratio, hopefully the shop miss quoted.

I can't see his location on my phone but if he's an Aussie, they call the whole axle assembly a 'diff' for some reason and the third member a 'diff centre'. Seven years living there and I still could not bring myself to call an axle a diff except when dealing with wreckers.

The only rig I'm aware of in Australia which ever received the 3:73 gear ratio was the Hj61 manual. All 40 series, petrol or diesel, got 4:11 because they never had to meet CAFE standards in Oz (which is why US Cruisers were fitted with 3:73 in '79).
 
Has anyone gone from 4.1 to 3.73 or even possible less on a HJ61 drive train (H55f)? My tach is not accurate, so currently I don't know what speeds/rpm I have with 33" tires. Certainly getting 60-65, I would like 75 comfortable on the HWY without excessive strain on 10+ hour road trips. I got a formula that has me at 2800 rpm @the above with 3.73s. thx in advance for feedback!
 
Back
Top Bottom