Different CASTER CORRECTION?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 8, 2005
Threads
11
Messages
33
Did anyone has tried this?



They say:
“Installing Downeys 2 lift front coils without correspondingly lowering the rear ends of the lower Strut Arms will cause the front knuckle angle (king pin angle for you old timers) to also rotate out of it’s ideal perpendicular angle. This is not a serious problem, but it does have an adverse affect on the vehicles’ straight line steering tendencies. Downey has developed this weld-on correction kit which does correspondingly lower the rear ends of the lower strut arms”.
caster correction.webp
 
I first saw those a few years ago, and couldn't believe my eyes.

I wouldn't trust those to be installed on a street only mall-cruiser. An edge to edge weld with no overlapping or lateral bracing of any sort?

Let's just say it shouldn't be a guy's first welding attempt.

Go with the MAF if you want a drop bracket.
 
Yes I have seen them installed. The Downey brackets do work well and you do have to weld them on. The draw back is they hang down very low under the vehicle and could snag on stuff when off roading. I think Man-A-Fre makes bushings for the front arms. Two per side that do the same thing. The only problem they are very difficuilt to install. The hards part is pressing the O.E. bushings out of the arms. You will also need some skill in measuring and geting the new bushings in the correct location since the are off set. They are a cleaner look when you are all done.
 
You will also need some skill in measuring and geting the new bushings in the correct location since the are off set.

There are templates available that work with both the OME and Slee bushings that simplifies the install making it pretty much fool proof.

But the guy offering them is gouging heavily on the price. :D
 
Hey Landtank,


I read about your caster plates and the bushing templates, but I don´t know wich one will work for my setup, can you tell me where can I meassure a distance that can tell you how many deggrees will I need to rotate?, how much your templates cost?
 
Back
Top Bottom