Difference between a 40 and a 55 front housing

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 24, 2003
Threads
208
Messages
2,210
Ok, so the fj55 front has centered spring pin, so this means castor would be altered compared to a 40 front spring. is the spring perch attached in a different position to take this into account on a fj55? i ask because i've bent a housing andhave a spare 55 series one sitting here.
 
bad_religion_au said:
Ok, so the fj55 front has centered spring pin, so this means castor would be altered compared to a 40 front spring. is the spring perch attached in a different position to take this into account on a fj55? i ask because i've bent a housing andhave a spare 55 series one sitting here.

Put it in. No discernable difference except for the bump stops.
 
what i mean is that due to the difference in the spring pin position, that will effect castor.

because on a 55 pack the spring perch will mount flat, where on a 40 the perch will mount pointing slightly down at the front, because the perch rides up the rear of the spring pack, due to the offset pin, i was wondering if toyota built castor correction into the housings.
 
bad_religion_au said:
what i mean is that due to the difference in the spring pin position, that will effect castor.

because on a 55 pack the spring perch will mount flat, where on a 40 the perch will mount pointing slightly down at the front, because the perch rides up the rear of the spring pack, due to the offset pin, i was wondering if toyota built castor correction into the housings.

I understood what you meant, but the differences in the spring were built into the frame geometry, not the axle.

Run it. :cool:
 
Back
Top Bottom