Diff Side Gear Spline Compatibility

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Mr. Toad

20 Year 15 Year 10 Year
Joined
Feb 7, 2005
Threads
63
Messages
1,643
I just swapped a 3.73 diff from an fj60 into the front of my 75 fj40. The axles do not want to spline in. Was I mistaken when I assumed that the '75 axles were compatible with the FJ60 side gears? Or am I going to have to swap some innards between the diffs?

Anyone have the correct spline counts for these axles/gears?

FWIW, the rear fj60 diff swap splined-in perfectly with the '75 rear axles.
 
The splines are the same. You have something else going on.
 
Thanks fellas. I've done this several times before and never had an issue. After posting, I tried the short side and it slid in smoothly after a momentary clearance push on the birfield. Went back to the long side and the problem appears to be at the birf rather than the splines.

So I'm thinking I didn't grind enough off of the '75 axle housing when I originally swapped for fj62 knuckles. So why did it go in before? Only thing I can think of is that I did the swap in 50 degree temps and it's in the 90s now.

So I get to spend next weekend with my grinder. :-)
 
After some thought, and then a search or two, I came to the same conclusion found in Page 2 of this thread.

Unlike the situation in the linked thread, my axle came out -- reluctantly -- but it would NOT go back. I loosened the steering arm (and thus the upper bearing), and it slid right in. So the knuckle must slightly squeeze the axle housing when everything is torqued-down..

Still, I'm going to take it all apart and grind away the problem next weekend.
 
Back
Top Bottom