Dead

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

New tank huh? This is getting expensive here. I believe I do have the original tank but then again I had to swap out the sender just recently and took a look inside. I didn't see any rust but of course my view was a little blocked. The line looks original though coming from the tank.
 
you could have a chunk of crap (rust/metal or ?) in the tank that gets sucked up by the pick up tube once and a while and blocks fuel flow. best bet is drain the tank flush it out or have a radiator shop flush it and if the inside looks bad enough line it with POR15 tank sealer kit. thats what i did when i had a simular problem. but mine would buck and spit at hiway speed when it happened but would idle fine. good luck with it!
 
:mad: Well, here it is 5 am and I have to be at work....no start. Turn turn turn and nothing. This is so inconsistent. It sounds as if something is settling in or blocking my fuel lines.
 
Take dist. cap off and clean it with soap and water. WD40 works to get you going when cap gets wet but makes problem worse in long run. 40's don't protect dist. cap from water splash and spray very well espescially if fender skirts have been modified.
 
tobydog said:
Take dist. cap off and clean it with soap and water. WD40 works to get you going when cap gets wet but makes problem worse in long run. 40's don't protect dist. cap from water splash and spray very well espescially if fender skirts have been modified.

He is running a V8 so the distributor is at the rear of the motor.

Your problem is air, fuel, or spark. Time to start troubleshooting. I would start with spark since it is easy to test and rule out, but I bet your issue is fuel. I know mine always is. Old rusty fuel tank and lines = clog.
 
mdjohnsen said:
:mad: Well, here it is 5 am and I have to be at work....no start. Turn turn turn and nothing. This is so inconsistent. It sounds as if something is settling in or blocking my fuel lines.

You need to start approaching this systematically - for an intermittant problem, guessing at the problem, then randomly replacing parts and declaring victory will result in a lot more "5am and...nothing" mornings. Not to mention unneeded expense.

You have to do the legwork to figure out the problem - there are no shortcuts.

Spark, fuel, compression - it's as simple as that. Follow the diagnostic recommendations the very patient people here have provided, before they give you up as unteachable.

Kirk
 
Did you narrow it down to a hard line, or soft line? Either way hope you found the issue.
 
Yah....it was rich. I was looking at getting new lines, tank, and maybe even a new distributor. All I needed was a $40 tank of gas. By the way it's a brand new stock LC sending unit. (yep...here we go again) I have the VDO Vison Series gauge that reads 0-90 ohm and realized it may be backwards (because when I filled it up it read as Empty) so I ended returning that for the opposite (90-0 ohm) but being that I kept running out of gas it still looks like it's still off.
 
Back
Top Bottom