Dash and tail lights not working

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 4, 2014
Threads
25
Messages
436
I checked the fuse it was bad, replaced it and the new fuse popped the second I turned the lights on? The only electrical work I’ve done lately is the cdl switch and the 7 pin? And before that all the lights worked perfect? Any thoughts on what to check first? Dimmer switch possibly went bad?
 
I'd look into the connector you pulled the number 7 pin out of. The rheostat isn't near that.
 
The fuse I used to replace it with was the back up fuse that’s located on the panel, being that it’s 25 years old from the factory and popped, I went and got some more fuses just to double check threw a new one in and everything is working. Will update later if that’s the problem and the lights go out again.. hope it’s just due to old fuses.
 
Fuse being old is not likely to be the problem. Most common problem for this that I have found is damage to the trailer wiring harness, often located in the right rear quarter, and may or may not run out to bumper/hitch.
 
Fuse being old is not likely to be the problem. Most common problem for this that I have found is damage to the trailer wiring harness, often located in the right rear quarter, and may or may not run out to bumper/hitch.

If the lights go out again I will start checking the wiring starting there! Thank you!
 
Look for what? I pulled the connector out and taped it up good. Didn’t touch anything else.
Look at all the other terminals and make sure one, or more, of them weren't loosened accidentally. These connections are 20+ years old and aren't as stable as they were when they were new. Also, based on personal experience, I always check the other connectors I moved out of the way to reach what I was working on.
 
Back
Top Bottom