Cylinder head resurface

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 19, 2017
Threads
39
Messages
114
Location
Great Barrington, MA
Hi all, First off let me begin by telling you that my fj ran fine, didn’t overheat and had good compression. I removed the cylinder head off of my fj40 to replace my valve stem seals which were cracked and hard as a rock. I checked for straightness and it’s good but the head has all these marks on it. Should I bring it to the machine shop and have him resurface if or should I just slap in anew gasket and not worry.
947859BE-B002-4ED2-A75D-2535001CB2D3.webp
 
What marks? All I see is some original factory milling and some gasket remnants. Clean it real good and put it back on.
 
it's off already, I'd take it to a shop and have them give it a once over, NDT, deck, valve seats, etc

there's this guru a few towns west of you in Woodstock if you need local advice.
 
Back
Top Bottom