Custom Bumper and Hitch

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 16, 2007
Threads
41
Messages
615
Location
Portland, OR
I started my bumper with approach angle and bare frame look in mind. It had to be able to tow anything I ever want (10,000 lb gross trailer weight) and have 10,000 lb tow points on the bumper.
IMG_0649.webp
IMG_0650.webp
IMG_0651.webp
 
The cross bar is 3/8 x 3 inch tubing. The actual hitch is 1/4 x 2 inch tubing. I realize this is way overkill, but at my fab shop, we like to over engineer structural components. The frame is 1/8" and the cross member is over twice that. You could pick the vehicle up and swing it around by that cross bar....yeehaw!
IMG_0623.webp
IMG_0624.webp
IMG_0625.webp
 
Oh, I forgot to mention....if you are thinking about adding similar weld on tow points, drill a couple of holes through the center of the plate you lay down against the bumper so you can weld those holes up before you put the tow point on. This will really stiffen up the plate as apposed to just welding the edges. The plate can wrinkle outward if you don't drill and weld.
 
Great write up. I want to do the SAME thing with my cruiser. When you cut the rear bumper, did you just plasma cut from each bolt hole? This is my only worry, I screw up cutting the rear bumper..
 
Very nice Boo! Any distance shots to get an idea of the overall feel?

I assume you cut off the old cross member? How much did you end up cutting off?



Oh, and wanna build me one? :lol:
 
Great write up. I want to do the SAME thing with my cruiser. When you cut the rear bumper, did you just plasma cut from each bolt hole? This is my only worry, I screw up cutting the rear bumper..

It's pretty easy...the bolt holes make it hard to get the measurements wrong. Just use a ruler and white marking pen and you'll be fine. In order the fit the hitch pin in the back you'll have to cut out a 4x2 gap in each side of the inside of the cross member. I'll snag a pic to better visually explain.

Very nice Boo! Any distance shots to get an idea of the overall feel?

I assume you cut off the old cross member? How much did you end up cutting off?



Oh, and wanna build me one? :lol:

Here are a couple of pics of the whole thing. The tire carrier cross member is bolt on and other than dropping that, I didn't cut any other cross member. Just let know when you want me to build you one and we'll get it done.
 
Beautiful welds, great penetration. Wish mine were that purty.
 
Back
Top Bottom