Cup Holder Modifica-she-on

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Not to hijack, but has anyone tried one of these?

pdpf1.jpg


or this?

f2white.jpg

That is neat...I had thought about something like this also but didn't look too hard besides the marine market. I think this would hold up better during wheeling...I'm a little concerned about mine being catapulted out of the holders. That's one reason why I tried to keep the length of the bracket that connects from the holder to the console short to reduce the spring affect.

Maybe you could use a similar T bracket for two of them mounted in the same location behind the console.

Where did you find these??
 
Great work on the cupholder, I am going to make one for mine! As for the 4 cup holders I have always wondered why my FJ62 had a double cupholder in the same spot on the side of the console where the FJ80 only has a single? Has anyone tried to mount the 62 cupholder on the 80 console? I am in the process of a bit of engine and interior restoration so might try to see if that will work as well.
Rusty

Thanks...It does seem like the side would be able to hold two of the same type of cupholder...side by side. Hmmmnnn...wonder if CDan can get those???
 
I put the rear seats back in to see if the drinks in holder would clear with the seats folded up. They clear just fine as long as the front seats are all the way (or most of the way back). As shown in the third pic, even with the front drivers seat all the way forward, it runs into the bottle but doesn't push it out of the holder...the bottle just doesn't sit flat in the holder.
DSCN0548.webp
DSCN0555.webp
DSCN0554.webp
 
Thanks tominator.

I did essentially this same mod on my '97 LX, and it works great.
I got my cup holder from Advance Auto Parts. I mounted mine a little higher on the console because I have the CD changer at the bottom. The lower edge protruded far enough that the back seats would rub against it when they were folded forward, so I trimmed off part of the forward edge so that the cup holder was more closely molded to the contour of the rear of the console. I'll try to get around to taking some pictures to post later.

I also bought two holder (one from Advance and one off eBay) that I used to construct a coffee holder for the front. The eBay holder had a bracket that mounted to the side of the console and had a flat piece on top. I then took the holder from Advance and mounted onto that flat plate (this worked much better than either of the holders individually). Again pics coming later.
 
Back
Top Bottom