Cruise disengages

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 16, 2006
Threads
6
Messages
28
Location
Floruba
Website
www.machinestart.com
Hello Folks..! Looking for some input on this subject. I have review past threads and none really describe my situation. I believe I have determined what might be my problem but, looking for the Knights of the Round Table (on this forum) for their opinions on my deduction.

The problem is that my cruise control has no code flashes (light stays on solid) but, yet will disengage the cruise if I use the turn signals while cruising....:bang: Another strange (& maybe related) situation is that when I have the 1996 LC80 running & in park then hit the turn signals or hazards the lock mechanism for the shifter clicks in/out with the turn lights.

I'm really beginning to think that it is the module associated with the trailering pigtail. Your thoughts and suggestions welcome.....! :beer:
 
Doesn't sound like something that would cause a code to me. I think you are on the right track with the trailer wiring, that's were I would be looking. Sounds like you are getting some feedback through the brake light circuit when you use the t-signal
(since hitting brakes cancels cruise during normal operation and you must press the brakes to release the shift interlock... the clicking you hear)
 
that sounds exactly like my recent scenario. was getting "crossed signals" due to road salt in the trailer harness connector. it was the type that attached underneath near the spare. changed it out with proper Hoppy harness and all was solved. good luck
 
Do your trailer lights work? i.e. Do all of the pins on the 4-prong connector perform their respective duties? That 5-pin to 4-pin convertor box in the right rear quarter panel is the first place I'd look.

If your trailer lights aren't right, disconnect the convertor box entirely and see if your problems go away.
 
Back
Top Bottom