Crank but no start... HELP?!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 11, 2007
Threads
70
Messages
1,693
Location
Burlington NC
My Cruiser has been sitting in my driveway for 3 months or so. I just replaced the front axle, and the alternator. Today, i finally refilled all fluids and bought a new battery.. Tried to start it up and it cranks, but it wont start...:mad:
I have been searching problems with the EFI stuff and fuel pump pproblems, and i tried to start it with the gas to the floor, and nothing... But you can smell fuel. I can hear the relays click like normal on startup.. Any help is appreciated.... The CEL does not come on with the key in on position...
How can i test the fuel pump?
 
Last edited:
Check the fuesable links that connect to the battery first
 
just checked them, and they look like s***! There both cracked with copper exposed...
Would that cause this to happen?
 
If you have a meter check and see if they are good or not..IMHO as cheep as the OEM replacements are, go ahead and replace them and keep the old for spares if they check out.

I fried one of the links on a trip where my wiring harness shorted...same symptoms of turning over but no start.
 
ok, so i was wrong, no CEL when key is at the on position, and im not losing any voltage in my s***ty fusible links...

Is there anything i could have hit, or disconnected to put the new axle on?
How can i check my fuel pump?
 
Have you checked for moisture in distributor cap, good connection from cap to coil?
 
yup, it looked like there was dried up drops on the inside of the cap, but it was dry as a bone...
 
EFI fuse...... or relay?

knowing you drown the rig a few months I would look at all fuse & relays.
 
EFI fuse...... or relay?

knowing you drown the rig a few months I would look at all fuse & relays.

Might be a dumb question, but, how do i check a relay???
 
1. Apply voltage to the coil terminals.
2. Check for continuity between the contact terminals.

No continuity = bad relay
 
There are three things that start a gasoline engine: Air, fuel, and spark.

You're getting fuel and air, but it's still not starting. x2 on EFI fuse/relay.
 
lay one of your spark plugs on top of the valve cover and have some crank the engine - look for a spark.
 
ok, so i was wrong, no CEL when key is at the on position, and im not losing any voltage in my s***ty fusible links...

Is there anything i could have hit, or disconnected to put the new axle on?
How can i check my fuel pump?

I could be wrong with the later model trucks, but no CE light = no start. On the older FJ80s the CE lamp is a tally from the ECU letting you know that the EFI circuit is energized and good to go.

How did you check your fusible links?
 
x 17 on the EFI fuse and/or relay.
 
He says he smells fuel - nothing so far indicates he has checked spark.
 
It still doesn't explain the fuel smell - hearing the relays etc. Is the CEL possibly burnt out?
 
I could be wrong with the later model trucks, but no CE light = no start. On the older FJ80s the CE lamp is a tally from the ECU letting you know that the EFI circuit is energized and good to go.

How did you check your fusible links?

My multimeter... No voltage drop at all
 
Back
Top Bottom