Converting a 1997 A343 to an A442.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

You would have to change the ECM to match the tranny. Then you would have to change the engine sensors to match the ECM. I'm sure the wiring harnesses are different so you would have to adapt or change out the wiring harnesses. The air metering is done differently so you would have to do something with that. Some dash gauges might need swapping (e.g. water temp gauge is different p/n between those 2 years.)

-B-
 
Apparently, the 95-97 Aussie 80 ECUs (those models still used the A442F) are integrated just like the US 95-97 ECUs and contain the same updates, so you could potentially use one of those, but (from a prior thread) I don't think the Aussie models come with EGR, so that would be a problem passing emissions here in the states.

I asked Ortho over at Wholesale Automatics in AU (perhaps the best source of knowledge on 80 trannies) because I was considering an extreme transmission upgrade and he said he wouldn't do the swap and he knows what he's doing.
 
Wow,

Short lived thread.

I just can't imagine it to be that difficult. Especially if you had a complete donor vehicle.

Drop in engine, tranny, and change out wiring harness may be time consuming for the last as I do not know how much toyota integrates their wiring harness. But they should match up pretty close.
 
I'd like to put an A442F in my 80....then I remember how it's electronic and how I like to get the underside of my truck all wet, muddy, and full of crap.

I'll stick with the fully hydraulic A440F :D
 
get the japan spec A442F. i have one in my 91 jdm 80 series with the 1HD-T. no electronics, full hydro
 
Back
Top Bottom