Column shifters Help Required

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

ok, that works, is it hard to take apart? to get the whole steering wheel and column apart?
 
Sandrider this happened to me. It came unthreaded and could still shift just a two handed job instead of one. I had mine taken to the shop but installed one later on, on my second cruiser. What you need to do as stated before is you are going to have to look the the shifter arm. On H there will be two small pins. You will need a punch or something similar to press both pins in at the same time. This will release the shifter arm. The shifter arm holds the "bolt" that came unscrewed in place. It is spring loaded however mine was frozen. I had to take an old srcrewdriver and pound on the end with a hammer in all directions to get the bolt to release. Once the bolt is out you should be able to screw it back into the turn signal column and assemble in reverse. This is the only way to do it without taking the shifting "rod" out. can be done but a bit of a pain to actually get the rod out from the engine bay. Good Luck.

:cheers:
 
Back
Top Bottom