Clutch issue

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 3, 2006
Threads
2
Messages
4
Being rather new to this board and owning an 1976 FJ40 just over a year, I can’t tell you how valuable this site has been to me. I’ve searched the archives and have not been able to pin point my problem. I have, within the past month replaced my bad master and slave clutch cylinder(s). Up until recently everything has been fine with the replacement. Until I found out when I very lightly press on the clutch pedal it will go to the floor and will not engage the clutch. However, when I press on the clutch pedal with more forces it works fine. I’ve tried bleeding the line a couple of times and made sure the pedal is at the correct height of 8.5 inches. Do I have air in the line or is my clutch bad?

Thanks in advance.
Matt
 
coolerman,

As long as I keep my foot on the clutch pedal it maintains pressure. If not , I have to pump the pedal to get pressure back to the pedal. Is there any slave adajustments that have to be made?
thanks
 
Not exactly. The adjustments at the slave are for the pivot fork free play and will not 'fix' what you are experiencing. Do this, wrap the hose going to the slave cylinder with a few layers of tape then pinch the hose closed using vise grips or similar. Now lightly put your foot on the clutch pedal and start slowly pressing it in. If you can make it go to the floor then your master cylinder is allowing fluid to leak past the cylinder cup. This could be due to a defective cup, wrong cup size or a cylinder that's over bored. You mentioned this was just replaced? Take it back and get another one. It's not uncommon for mass rebuilt cylinders to not work properly. If you don't have the FSM send me your email address and I'll send the clutch section to you in pdf or tiff file format.
 
Thanks Coolerman!!!!, will try tonight or this weekend. I bought both the master and slave from SOR. I did notice when I puch down on the pedal when it does not have pressure the level in the cup does tend to rise, is it supposed to do that. Thanks again
 
Hmmm, you know, I have never actually watched the level while pressing the clutch, but looking at the way it works it should not rise, it should remain steady. If it's rising you are getting fluid by-passing the piston cups. Contact SOR and explain the problem and give them a chance to give you advice or offer to replace the master cylinder. Be ready to pay shipping charges BOTH ways...
 
Back
Top Bottom