clutch help

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 12, 2005
Threads
12
Messages
53
OK, I am having trouble with my clutch or master cylinder or something. When I put the the 40 in gear and hold the clutch down, It loses its pressure and tries to take off if I don't release it quickly. It does not do this all the time and does not appear to be slipping. It seems to be losing pressure. I can shift without problems going down the road and when I stop. It only happens when I put it in gear and have to sit there for a couple of seconds that it tries to take off. If I go ahead and take off quickly, I don't have any problems. It started off by losing pressure a little slower, but now I am down to about 2 seconds before it is losing the pressure on the plates. Could this be a clutch master cylinder or slave cylinder problem or could I have air in the line? Thanks for anyones help in advance. RG
 
rocman1 said:
Could this be a clutch master cylinder or slave cylinder problem or could I have air in the line?

Yes, yes, and yes. It could be any of those things. Try bleeding the
system first but I doubt that's going to do it. I would rebuild or
replace both components at the same time if the bleeding doesn't
work (and it won't, is my guess).
 
Pull the boot off your slave cylinder. If there is alot of fluid, you slave is leaking. This tends to wear out faster than the master and is less expensive to fix.
 
Ok, I looked at the master cylinder and the slave and the inside of the truck. There are no leaks from any of them. There is some fluid that looks fresh around the fly wheel cover. I will have to take it off to see any more. I don't know if it is from there or from the oil pan gasket as of yet. Thanks for the help from everyone so far, RG
 
Take the cover off of the clutch master cylinder fluid reservoir and familiarize yourself with the feel and smell of brake fluid. Notice that this is probably not the same fluid dripping off of your flywheel cover.

Did you pull back the little rubber accordion dust boots on the cylinders when you looked at them? If so and they were bone dry, then have someone else work the clutch while you inspect the rubber hose for bulging.
 
ok, I checked the cover of the slave cylinder, nothing there. I will get my wife to work the clutch tonight and check out the hose. I hope it is that and nothing else. The engine is not revvin up when I take off, just accelerates normally and when I down shift it and let out the clutch you can definatly feel it slow down so I don't think the clutch is slipping. I talked with Poser a couple of days ago and he thinks it might be either the master or the slave just going bad. I am checking on buying a couple of these from one of he board members. RG
 
I just put a kit in Tate's clutch master last week and was having the same problem. I could not get the front of the master cylinder off so I just replaced the cup on the piston. This did not cure the problem. I had to take a BFH and a pipe wrench to the large cap on the end to get it loose. I replaced the rubber cup/gasket and the problem was solved.

Russell
 
Back
Top Bottom