clutch adjustment possible?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 9, 2005
Threads
26
Messages
82
Location
Decatur, Ga
Clutch pedal comes out almost all the way before the FJ starts to go forward. Time for a new clutch.
When I had an old VW bug, and it did this, I was able to tighten the clutch cable and get some more life out of the clutch before having to replace it.
Is there somthing that I can adjust so that I can get a few more miles out of the clutch? Like to be able to wait until spring before I put a new clutch in there. As it is, it looks like it might be a Fall weekend project.
Thanks!

-Drew
 
You can adjust the pedal free play at the slave cylinder. (near pass side frame rail)
 
Texx said:
You can adjust the pedal free play at the slave cylinder. (near pass side frame rail)

Do I adjust the rod towards the back (behind the shift fork) or to the front (towards the slave cyliner) A little goes a long way?
 
Just guessing, but I would shorten the rod, it should engage the clutch sooner. I would wait until someone else says so, though.. I havent gotten to that part yet on the cruiser, thats just a common sense guess.
 
I have been dealing with this recently...You should screw the nut away from the slave cylinder, if you don't want to deal with you master. Or you could do the same for the master, and leave the slave. A little does go a very long way, and You will have to feel it out. It shouldn't take very long (half hour at the very most), just make sure that you have a small adjustable wrench and a medium sized screwdrive if you are going to adjust the slave. Much easier.
 
I would start with 2 things before I even thought about swapping the clutch.

Bleed it and adjust the push rod at the slave.

Huge improvement on my rig. I later replaced the master, it feels new now.
 
Back
Top Bottom