Chop Saw?

[MrMoose]

Does anyone have a chop show that can make 2 quick cuts for me? New winch plate for the 80, and I just need to cut 1"-1.5" off each side. Since it'll sit on top of the frame rails, I'd like to make a nice, clean cut, instead of working it with an angle grinder.

Thanks!

 

[Bret]

Sawzall?

 

[karas]

I just have a grinder with a cutting wheel. I do have a sawzall.

 

[Fitzgerald]

I've got a chop saw. It's all yours whenever you need it.

 

[Pops]

Does anyone have a chop show that can make 2 quick cuts for me? New winch plate for the 80, and I just need to cut 1"-1.5" off each side. Since it'll sit on top of the frame rails, I'd like to make a nice, clean cut, instead of working it with an angle grinder.

Thanks!

I have a Cold Cut saw like a chop saw for Metal. Doesn't heat and warp the metal.

 

[MrMoose]

Found one and got my winch plate cut early this morning. More to follow on that. Should have it wrapped up tomorrow...

Thanks for the help!

 

[Springs505]

Found one and got my winch plate cut early this morning. More to follow on that. Should have it wrapped up tomorrow...

Thanks for the help!

Be sure to post up a picture or 2 of your updated winch install.

 

[MrMoose]

I will. And if anyone is looking for a winch plate, I highly recommend the one sold by Barnes 4WD.

 

[Fitzgerald]

I have a Cold Cut saw like a chop saw for Metal. Doesn't heat and warp the metal.

Ohhh....nice. I'm jealous.