Center console thougts

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 14, 2005
Threads
41
Messages
531
Location
Iceland
Hi all, i´m thinking about removing the center console and make my own istead. The original is far to low to rest your arm on while cruising.

Does anyone have pics of home made consoles?

I would also like to make space under the console for a webasto air heater i have. I also had an idea of fitting a cooler from a small 12 volt travel cooler into the console. How cool would that be...
Has anyone here done that?
 
The 62 is a lot different. There is not much space between the seats in the 80s and the console is shorter because of the huge hump for the tranny and the Ebrake is more of a pain and you have the rear heat vent to deal with. It is easy to remove. Two screws on the sides of the shifter cover and two 12mm head bolts in the bottom of the console. As for depth, on the edge I can fit a gazetteer atlas. Metal would be a better way to build and get more space. Then it is plenty strong but not overly thick.
 
Thanks for the links.

Eric, do you have any pics during the build.

Im thinking about replacing the rear heater with a webasto heater. I must figure out a way to make it fit under the seat or the console.

I´ll might remove the console tomorrow and have a look under there.

Was looking at the pics in this https://forum.ih8mud.com/showthread.php?t=133959 tread, there seems to be some room there if I remove the rear heater.

The console I made for my 62 can be seen here http://www.pbase.com/haffinn/image/47955675 i´m thinkng about similar look.
 
Last edited:
Back
Top Bottom