Caster Correction - Help!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

what is your hub center to flare measurement? I find it hard to believe you need to use plates with OME mediums but it's possible I guess.

22 inches.
 
With that lift and caster it should drive OK. Have you inspected for anything loose, wheel, trunnion bearings, bad bushing, loose bolts, could be on the front or rear, anything that would allow an axle or hub to shift/move?
 
Most bushings up front has been replaced. Front axle has been rebuilt. All tie rod ends have been replaced. This issue has baffled me for some time and I have no idea what is going on.
 
Back
Top Bottom