carburator

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 8, 2006
Threads
3
Messages
6
Location
st augustine fla
having a big problem after cleaning and adjusting the orginal AISAN SD-40 carburator on my 66 FJ-40. engne when hot will run after turninoff key it will run til it pull the gasket out of the sight glass. hat do I need to do, I ave the idle set a 500 rpm,s and it runs good till sut down. pleas help:confused:
 
No carb solenoid on that. I wonder if the problem is your ignition switch not working.
 
timing would be my guess. Is it running or stumbling along? If its running i second the ignition switch but if its stumbling its the timing( to retarded)
 
"Pull the gasket out of the sight glass"? Now that's one I hadn't heard of before!

Engine run on probably due to high idle AND poor timing. Try shutting it down by letting the clutch out instead. Guaranteed to mask the symptom until you track down the problem.;)

As far as the gasket, I'd venture a guess that A, the front of your fuel bowl is warped [I've seen 4 or 5 SD-40s with that issue, AND B, your air cleaner is too restrictive, making it easier to draw air in thru the warped fuel bowl than thru the air cleaner.

If it's an oil bath air cleaner, clean the element and change the oil. If it's a paper element [not factory until '68] get a new filter cartridge.

Best

Mark A.
 
Back
Top Bottom