carb wire?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 7, 2006
Threads
8
Messages
29
Carb.

Hello everyone, just a quick question, on my Carb there is a black wire comming out of the solenoid that has gotten the chop, does any one know what it is for... is it a ground?, if not, would it be a 12v solenoid?

thank you ;p

Oh its a 78 FJ40, manual, petrol...
 
Legend, thanks for that, Hey the butterfly valve, is that ment to just stay open?? mine seems to be open all the time? can any one put up some pics of there carbs, so i can see if i have anything else missing !!. just trying to get the beast started at the moment !!,
got a good KG of sand out of the starter :confused:

appreciate it ;)
 
Unfortunately, it has been my experience that when the solenoid wire is cut off of the solenoid itself, the solenoid has usually been tampered with internally as well in order to make the carb run at idle. Assuming that the truck ran in that condition before, that may be your case as well.

Soooooo, you might want to pull the solenoid off of the carb and inspect it closer. I know you said that the truck is a 78, but for the moment I am not going to assume that the carb is.

If it is a late 69 thru 74 model, the solenoid is secured to the air horn by two screws of the same type as hold the air horn on. Inside there is a brass rod with a pointed end. This end is often butchered on the solenoids I've seen with the cut wire.:frown:

If it's a 75 and newer carb, the solenoid threads directly into the air horn. On these models, there is a small O-ring that fits on the far inside end of the solenoid, serving to seal it to the air horn. There it often the case that the O-ring is simply missing.

Hth

Mark A.
 
Back
Top Bottom