Carb Questions

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 11, 2005
Threads
9
Messages
33
Location
Flagstaff, AZ
I have a 1970, had problems with my carb (ISO 60191 stamped on the carb), butterflies were froze up and consequently snapped off as I was rebuilding. Ok I bought an Asain carb (ISO 8F21) and was going to rebuild it. Many things look different on this carb than the one that was on my cruiser. I have heard others using this carb on an F engine. Can someone clue me in on the differences and will this carb work on my 70 F engine? Thanks for your help.

Darrin
 
There are a LOT of differences between them, and unless you were stuck in the middle of nowhere with no other choices, I wouldn't say it was worth the effort to try and make it work.

1. The carb takes a different air cleaner.
2. The carb is not the same height from the intake to the air cleaner.
3. The carb was designed to run with rod linkage; your 70 was designed to run with cable.
4. The carb has a vacuum actuated secondary, which is much more finnicky then the mechanical secondary on your 70. Unless the planets are aligned just right, they work poorly.
5. It's jetted for a bigger engine.

IMO, I would look for a more compatible core and resell that one. I might be able to help with both.;)
 
Darrin, the carb you posted for sale in the fs section, even though it is marked as a 78 carb, appears to be of the 73-74 vintage, based on the return line configuration it has [like cabron's 74 I just rebuilt]

Based on that pic, I would change almost everything I put in the first post and say that with minor modifications it could definitely be made to work on your 70.

First and easiest thing to do would be to just cap off the return line [the one on the top of the air horn] and put it on the truck and see if it will even run. Then, if it runs ok, look at the linkages on the primary throttle shaft and consider what it will take to swap them over.

If the carb doesn't work well, or if swapping the linkage worries you about breaking anything else, you can send both to me and I will build you one good carb out of the pair using the best parts from both.

The carb on my 68 is actually just such a composite: part '72, part '73, part '74.;)
 
I'll chime in and tell you, hands down THIS IS THE BEST THING I HAVE DONE TO THE MOTOR TO DATE. Smooth idle, easily sits at factory specs, cold starts and hot starts are that of a new car. Even my master tech tht turns wrenches for me when it's 15' here was highly impressed at Marks workmanship
 
Back
Top Bottom