Carb float issues ‘71

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 29, 2010
Threads
46
Messages
126
Location
Escanaba, MI
Hello—

I’m bringing back a rescued ‘71 40 from the dead. I’ve rebuilt my carb. Idle is beautiful, timing and points gap good etc. When I give it gas, it dies unless I pump it a little to work it back to idle. Currently undriveable.

I’ve got way too much gas in the fuel bowl site—like it’s flooded with gas. . Im certain the float is adjusted to factory specs (I pulled it twice to check!).

Is it normal to have to adjust the float outside the specs to try to get the fuel down to the halfway point on the glass sight? I’m tempted to adjust it but am just guessing at this point.
 
Check your needle valve for debris.

Adjust the float if necessary, but focus on that needle valve, odds are there is something stuck in the seat.
 
No debris in the needle valve. Seems to seal (just blowing air into it anyway when float raised).


I fought the same thing for a while, everything looked spotless but it would still flood the carb out on occasion. I tried adjusting the float but to no avail, finally dug around a bag of parts from a carb rebuild and replaced the needle valve and spring, I haven't had any issues since.
 
Funny that you say that! I also suspected my choke bushing was loose so I went ahead and replaced the whole air horn from a parts carb I had. Now it starts great with choke on, I can rev it and drive it with the choke on-ish but it won’t idle with the choke off. More adjustments ahead I guess.
 
Back
Top Bottom